Contact Us

Ningbo Bote Auto Sealing Co.,Ltd

Address: 818# North Danshan Rd, Cixi, Ningbo, Zhejiang, China

Tel: +86-574-63028855

M/P: +8615990580000

E-mail: botegasket@263.com

Precautions For Installing Stainless Steel Wound Gasket

- Nov 08, 2017 -

Stainless Steel wound gasket is now widely used in a variety of industries, it is the key part of the department, to the normal operation of a very important significance, then you know the stainless steel wound gasket NOTE? If you do not know, the next introduction will be of great help to you.

The following points should be noted when installing stainless steel wound Gaskets:

1, before installation carefully check the flange, bolts, nuts and gaskets of the quality, carefully check the flange or interface installation, there are no bias, wrong mouth, open mouth, wrong hole and other defects.

2, flange or seal surface must clean up, gasket surface and bolts, thread does not allow adhesion mechanical impurities.

3, gaskets can not be installed, should ensure that the pressure evenly.

4, tighten the nut should be evenly, the bolt should be symmetrical, evenly divided 2 times-3 times to tighten, so that the gasket pressure evenly.


Related News

Related Products

  • Low Load Spiral Wound Gaskets
  • Graphite Exhaust Muffler Seal Ring
  • Graphite Tape for SWG
  • Ring Joint Gasket
  • Reinforced Graphite Gasket
  • Non-asbestos Compressed Sheet